|
| Product Features | |||
 |
Power rating 8.5kW or 9.5kW (nominal) |
|
|
|
Thermostatic control* ensures temperature does not increase by more than +1 degree C of the setting | ||
|
Push Start/Stop button with phased shutdown | ||
|
Power 'on' indicator | ||
|
Temperature control with numbered dial | ||
|
Push button flow selector for: cold, low, medium and high | ||
|
Concealed pipe connections | ||
|
3 mode sprayhead | ||
|
Soap dish | ||
|
Available in White/Chrome, White or White/Gold effect (8.5kW versions only available in White/Chrome effect) | ||
|
2 year guarantee | ||
|
Click an image to enlarge |
 |
n/a |  |
 |
| Millennium Thermostatic | Side view | Front view | Riser Rail |
 |
 |
||
| Internal 1 | Internal 2 |
| *Temperature stabiliser |
| The unit will
maintain the user's selected temperature when pressure changes occur
(within the pressure range stated in the 'Site Requirements - Water'
Section) and where there are fluctuations in voltage (within the UK supply
tolerance) and inlet water temperature.
|
| Site Requirements - Water |
| Installation must be
in accordance with Water regulations/bye laws. To ensure activation of the
heating elements, the shower must be connected to a cold rising main with
a minimum running water pressure of 1.0 bar (14.5psi) at a flow rate of 8
litres/minute (9 litres/minute for 9.5kW) and a maximum static pressure of
10 bar (145psi), as measured at the inlet of the shower. The unit must NOT
be installed where it will be subject to freezing conditions.
Instantaneous showers can have the water supply taken from a cold water storage cistern provided the minimum pressure and flow rate requirements stated above are met. It must be an independent supply to shower only. If it is intended to operate the shower in a hard water area or at pressures outside those stated please contact Triton Customer Services on the number below. An isolation valve must be fitted to allow independent isolation of the water supply for service and maintenance. To comply with water regulations the sprayhead, when hanging loose on the flexible hose, should not fall below the top of the bath or shower tray. If it does, then a double check valve, or similar device, must be fitted to prevent back-flow. If in doubt, contact Triton Customer Services who will advise and supply a suitable device if required. Further advice and specifications are available by calling TRITON Customer Services 024 7637 2222 |